Free Shipping Over $149
Norton Seal

LED - Retrofit

The LED retrofit downlights in this category consist of an integrated module - LED array, driver and power connector designed to fit into existing recessed downlight housings.

When replacing CFL downlights, the lamp(s) and trim need to be removed from the downlight housing and the existing CFL ballast removed or disabled. In addition, re-wiring is usually required to connect the LED module to the power supply. Torsion springs or clips on the LED module pull the trim tight against the ceiling.

When replacing existing incandescent downlights, the lamp and trim need to be removed from the downlight housing. The LED module is installed with a pigtail connector base that screws into the socket inside the housing. The module can then be snapped into the housing with torsion springs or clips that pull the trim tight against the ceiling. The installation does not require re-wiring and normally can be done by facility maintenance staff.